I am in the middle of building built-ins for our library and am trying to decide on lighting. The width of the built-ins is 14 feet and I need a row for each shelf, so a total of 5 rows of 14 feet each. I have no specific preferences other than the items listed below:

1. Warm white light
2. I'm thinking COB with the built in diffuser, but am flexible
3. Need to be able to control them from Home Assistant, WLED, and locally (though locally can be done with Zigbee buttons and Home Assistant)
4. I need a minimum of 3 zones able to be controlled separately:
   1. Top row
   2. Middle 3 rows
   3. Bottom row
5. Need to be able to power from one supply if possible
6. Not cost a bleeding fortune

Anyone have any thoughts, suggestions?

Thanks in advance,

~Conan

Hey, I want to replace the broken driver for my LED Lamp.

I found a couple on amazon bit I‘m not sure which to choose.

The current driver says

Waiberlon
Constant Current LED Driver
Model: HLV50025LB
SEC:42-50Va
0.750
PRI.:220-240V~50Hz 0.14A(Max) )>0.95
SEC.:42-50V. /500mA
ta:50°C tc:85°C
POUT:21-25W
Max. output voltage(no load):62VDC

Is it possible to take something with more current, e.g. 700mA like the second picture?

Thanks in advance!

Hello,

I am trying to put in some under-stair LED strips in my home. I want to get a sensor to detect when it gets dark and then turn on the under-stair lights automatically. Surprisingly, nobody sells something that simple, or it's wicked expensive. Is it easy to do myself? I have no experience with circuits/soldering.

I found these LED strips and a light sensor on Amazon, and I'm hoping I can put the two together, though I don't know what I'd have to solder or where.

Amazon Items

Sensor - https://www.amazon.ca/gp/product/B0GZ83JTX9?smid=A3FH9PN6K47KUI&psc=1

LED Strip - https://www.amazon.ca/gp/product/B088YP35JW?smid=A3W1ARFCWJR0HL&th=1

Thanks in advance!

I have 2 types of LED spot lights and I would like to use them on a 24v system.
I believe one of them is rated 12v - 30v and the other one is just 12v

I have tested both of them on a 24v system and they seem to work just fine and I cant tell the difference.

Can someone tell me what’s the difference between them 2 (see pictures)
And would it be fine to run both of them on a 24v system (they will be wired separately in separate rooms)

Thanks in advance

Howdy! I have this rad LED bamboo tree that's been broken for years. The cable to the power supply ripped and at this point I have no idea how it was configured.

Basically it has three 2-pronged female outputs hanging from it, and at this point I just need to get a new power adapter and an extension cable. This is not my wheelhouse! Anyone have any advice?

It's almost identical to this but three times the size

https://jamaica.desertcart.com/products/11925155-lightshare-new-4ft-144led-bamboo-tree-light-green-for-home

For outdoor light. Par38 is too directional. Is there anyway to convert it or make it omnidirectional like an a19 bulb? Thanks

Hi everyone! Does anyone know if connectors are available for SMD 2835 LED strips, 10mm wide, 2-pin, 24V? I’m having trouble finding connectors that fit properly.
Any recommendations or links would be greatly appreciated. Thanks!

https://a.aliexpress.com/_EGrRCr0