Some of y'all haters (boomers?) didn't like the last one. This one is nice and plain for your old curmudgeony self. 🙄😂

Full clicky kit and Spark back paddles, K-Silver JS13 TMRs, black Luna shell from extreme rate

Thoughts on my design? Equipped with K Silver TMR and Paddles.

Recently i installed tmr in my duelsense edge module. When i tested it ,my controller blinked blue for 1 second then it began blinking white . I dont know what happened i soldered everything , and tested everything . Then after that i remove the tmr stick . Why this happens? Can anyone help? And i need to mention that i didnt use any IPA while doing this . I used some flux and tried to cover all components with kapton tape. What could have cause this?

I bought a pair of gulikit tmr thumbsticks to replace my old ones that had bad stick drift and asked my cousin if he could do the soldering work for me since he has the tools and knows more about soldering than me.

Unfortunately the soldering iron he used wasn't the best and I don't think he did that great of a job but I have no reference of knowledge to compare it to at all.

Is the board badly damaged? Would it be ok to still try to install the new thumbsticks? I ordered a kit on Amazon that I'll be using to do this myself when it comes. Should I try a different controller at this point?

Not even sure if this is the right sub to post in, but i had an older dualsense which had quit bad drift. So i attempted to replace the sticks with new hall effect ones. Now the left joystick will only read as pointed left and the right one will only read as pointed up. I tried calibrating it and it made no difference. Has anyone fucked up their controller like me?

My L1 button randomly stopped working earlier and I'm at a loss on what to do with it, it's not working whatsoever apart from when the controller gets turned on - for a brief second and then it stops working again. I'm unsure on whether this is a hardware issue or a software issue.

Attached are photos of both the L1 (the first image) and the R2 silicon things

Hello I'm sure someone's asked this before but figured I'd try myself. Time and patience aren't on my side and I'm looking to gift one of my Edge controllers to my nephew but I'd like to make his own so I'm looking for a mail in service that will replace the buttons, triggers, and bumpers and such to make them mouse triggers and possibly a shell swap if anyone can lead me to that it would be great

I’ve done most of the troubleshooting I’ve found online , I’m looking to see if anyone else has weak vibrations playing sparking zero with the spider man control.

So I've been using my Dualsense on my PC for almost a year with no problems, it charged and connected with bluetooth.

Now it doesn't charge on it's own and i have to force the charge via closing every single software possible and opening PS accessories. It also doesn't connect with bluetooth on its own and i have to do the pair each time.

any kind of help is appreciated