Bought this reverse camera off eBay for a fiesta hopefully it will do the job but where do I start I bought everything I needed I believe so it should work

1998 Subaru Impreza L. It is a manual and a Coupe.

I am trying to lower the rear differential to access the top of my fuel tank. Thus I started by trying to lower the differential front member. I got the passenger side lowered just fine. I started on the driver side till suddenly I heard a loud POP. The bolt on that side is now free spinning, not tightening nor loosening. How can I get the bolt off to lower this?

Figured I would share this here. I've been doing diy auto repairs for over 20yrs . 😂 Sometimes it's fixed correctly sometimes it's fixed good enough never any bad advice but a few tips n tricks on the random vehicles I save from the crusher. If this post isn't allowed let me know no harm no foul have a good one n enjoy

Also why does my discs look rusty after i washed them?

So I’m replacing my ball joints control arms, inner/outer tie rods, sway bar links.
In Texas and all bolts are ruśt free. Soaked all bolts and nuts with PB Blaster before I started and during disassembly.
After removing the cotter pin I couldn’t get the castle nut off of the ball joint. Had to use a wrench. About 1/2” clearance between top of bolt and steering knuckle.

Anyway, removed cotter pin, PB Blasted it and let it soak for at least an hour, blasted it again, even torched it but couldn’t remove it. Now the damn nut is stripped!

I don’t think I can get a nut splitter over the bolt and don’t think it would split the hardened nut anyway? Thought about drilling it but again it’s a black hardened nut. Seems like my only option is to cut it off with an angle grinder?

What do you all think? Thanks

Is it below dashboard?

Recently replaced exhaust manifold on 2008 Chevy Colorado 2.9 , can't figure out where to connect this loose ground wire which is apparently essential for the truck to fire up - wire is in the above picture - tried several areas no luck so far

will a straight repair sleeve work or is the rot to close to the bend/angle? will it not seal? I'm noob , first time doing this.. just cut right behind the rotted part?

Hi all, I’m trying to replace the chrome trim on my 2026 Tahoe, does anyone know how to release these push clips on the trim? Is there a specific tool other than standard trim removal tools?

Thank you in advance!!

Also would the best option just to be cut it off and replace using a regular bolt?

I know it would be best to just replace it, but I can't afford that right now, and driving without it in my state will cause me to fail my yearly inspection.

I'm wondering if I can take it off and use a rubber mallet or something to bend it back into a closer to normal shape, then use something like JB weld on the cracked tabs, replace some clips and try to get it mostly back on correctly, with minimal zip ties. But I've never tried to fix a bumper cover before and I'm not sure if that's the best approach.

I would appreciate any advice that doesn't involve spending more than $100, atleast until I can properly replace it.

TIA