I want to remove the 3 middle studs here and install a pocket door. The upper floor joist direction, and the way this is set up seem like it is load bearing.

On the other hand, the house plans call for a pocket door here and it could very well be a pocket door header that was changed last minute.

None of the cripple studs above touch the beam, I can fit my finger in the gap of some of them. The 3 studs I want to remove also don’t touch the beam.

So it looks like it could be either. The gaps look like there is no direct load path for what I want to remove. There is also a large laminate beam in the middle of the room to support the upper floor joists. This is a small 57” wall in the corner.

I’m building a wooden cabin using 190mm (~7.5") wide by 40mm (~1.5") thick horizontal siding boards. I picked this wide board specifically for a more massive, solid look, but looking at the sample, the V-joint bevel is only about 5mm (~0.2") per board, which feels way too small and completely out of proportion.

When I asked my contractor if we could make the V-groove wider, he claimed it's a bad idea because it would trap rainwater and cause leak issues on the exterior.

Is he right, or is there a way to make a wider bevel that looks proportional on a board this size without weather/water issues?

For example, would changing the profile to around 10mm wide and 7mm deep per side (creating a ~20mm total V-groove) keep a steep enough angle for water shedding, or would that cause problems on a 40mm thick board?

Edit:
Just to clarify: these aren't pre-milled boards I bought off the shelf. The contractor is milling, drying, and processing all the timber himself. The piece in the photo is just a sample he prepared for me before running the full batch.

Edit 2:
As for the size, it's purely about the aesthetic I'm aiming for. I want to recreate the look of a heavy, stacked square-log cabin rather than standard siding boards. On a 7.5" (190mm) wide board, a 5mm bevel gets lost from a distance, making the wall look almost flat. A wider 10mm bevel creates a stronger shadow line that visually separates the boards and gives that chunkier, massive log effect.

I am exploring different work opportunities between: Rodman, carpenter and flooring installation. How busy would it be as a flooring installer ( vinyl, hardwood, carpet ) ? Looking for opinions from people in the trade only ( local 18 ) .

The start of a brand new moldy adventure

I am trying to figure out if this is an old or new leak. The windows were replaced 5-6 years ago by the previous owner. When renovating I found T&G covered up under the current wall and under this window it was rotted. Under the T&G everything was dry but the stud and sill plate were toast. But some one had installed new 2x4s when installing the new window that appear to have no moisture damage. No one would put rotten T&G back over the new 2x4s?? Is this window leaking or is this old damage from an old window and someone was super lazy and maybe accessed the cavity via the exterior sheathing and didn’t touch the T&G??

Replaced a cellar door, having issues with colder temps on the floor in the winter. Also added some insulation underneath the floor

On my blueprint my math was a little off but it worked in my favor by giving me more space on top 😅