Don't know of this is anything of interest but hey, why not? Short video of my CB500/650, mostly because of some earlier comments about exhaust and exhaust sound 👍

This is my first road legal bike. Got my motorcycle endorsement with this thing 79 cb650 I put together. It’s fun to rip around town but I feel like it’s just not enough. I absolutely love this bike but the gearing is just terrible and makes longer rides not super enjoyable. Pics are from pick up and how it sits now. Got it not running had to go through most of the wiring due to pinched wires, rebuilt the carbs, clutch pack, cognito rear sets, rear hoop, lights, delkevic 4-1, and more. Should I sell? Trade? Keep and buy a second bike?

Want to show off my project. Frame is a 03 yz450 with the backbone stretched 4 inches. Lower half of the frame and engine are from a 82 xj550. Adding 80lbs to the yz for 5 more hp and zero torque

So many of you guys have been asking to see more of my build, and that post was my first ever Reddit post and idk how to work this app so I’m just gonna make another post. Anyways, I’ll post some vids in the comments as well. I’m not a photographer so bare with me

Yamaha is 750

Hi guys! I need advice with a problem I have with my modified VanVan 125.

Years ago I modified my VanVan to turn it into a Cafe Racer. For doing so, I bought an Honda cg 125 tank, my workshop applied the inner anti-corrosive painting, and another workshop painted the whole tank.

The problem is that there must be some bad interface, and the gasoline vapors are creating these bubbles below the painting....

How could I improve this? First I tried to seal everything with a bicomponent glue (Araldite) but it didn't work. Now I am thinking on putting some kind of NBR rubber seal around it, but my fear is that gasoline would get trapped below...

Obvious answer is repainting, but it's expensive 😓

Help!

The first picture is how I got it. Luckily the guy had kept the chopped frame bits and the seat, rear fender, etc. I was stoked to get this bike back to the way it came off the assembly lone. Some cafe builds are sick but a two-speed semi-automatic Honda 400 ain't it.

Work in progress. And btw, I built the RMCR before Harley did.

CG150 OHV 2v

PE26 35-110 JFN 3rd

Dual SNS stifd suspension (Basically a hardtail if you're alone, only plays if you have a pilon)

DualSportR + SawtoothF tire setup

Mainly used for Food delivery and Occassional joyrides

Dealing with a hacked up frame for an old Kawa. The rear peg bosses were cut off leaving open frame tubes. ID is about 3/4",OD is a hair under 1". What are some options that don't include cheap plastic plugs?

I can mig well enough to fool people from 5' away if that helps.

Thanks!