Has anyone experineced this is with Paxton Net2 Handles>

we use some at my work and they seem to start slipping and degrading after a year?

I have plenty of power to use inside this thing. However, there is no posts to mount a Brivo PSB that uses a 4 wire connection to provide power the ACS6100DB door boards. Can I power these door boards from the altronix power supplies inside the enclosure? The 4 posts are +12v, GND, POWER DET, Earth Ground. Has anyone tried to power these with anything but the PSB?

My controller is throwing a code 91 during open AND close, even with the gate arm disconnected from the unit. The unit is a little over a year old. Some steps I’ve already taken:

-Power cycled by disconnecting AC and battery

-used multimeter to check AC and battery, both check out

-reset limits while under load and not under load

-checked wiring, reseated connections

-checked for any signs of undue load on the motor, no noise, vibration, nothing

-replaced APE, which oddly had it working fine for about 8 hours

-ordered new battery just in case, not arrived/installed yet

Any ideas? It’s driving me nuts, thanks!

Hello,

We had a KT-400 slave controller go belly up on us. We replaced the controller and updated the serial number under that controller in EntraPass, however it still isn't seen/communicating. Are there any other steps that we may have missed?

Thank you!