I'm building a new home and looking for recommendations on a hardwired, multi-zone whole-house audio system speaker placement. I'd like music throughout the house, independent zone controls, and one-way paging from my phone through the same ceiling speakers. (The family room TV will have a completely separate surround sound system). I'm still under construction, so wiring is flexible. I've attached my floor plan and would appreciate suggestions on ceiling speaker placement for now (can discuss equipment later). Thank you for the help!!

Just curious why more people don't try to start their own speaker business given the amount of experience/understanding shown in this sub.

I need cheap speaker grills to temporarily cover 8inch speaker holes in the drywall ceiling until I can afford to get the speakers installed. All the wires were ran and holes cut but I just can't get all the equipment right now. I've been looking for something that might have spring clips where the clips compress as I'm pushing it in then expand out once they get above the drywall thickness so it snaps in. Has anyone seen something like this? Maybe there is a brand of speakers that have covers that mount like this and I can just buy the covers? Or any ways I can rig a certain speaker cover to do what I need?

These are from the 80s I think and the plastic or whatever it is peeling and flaking. Messing up the base sound. Otherwise they sound good. Anyone know what needs to be replaced and where I could get it? Thanks for looking.

Reddit recommend I crosspost to this community so thats what I'm doing!

Hi, i'm developing a 96khz 24 bit lossless wireless iem drivers that sits on your ear. It will have usb type c male transitter without snd driverd or app, purely usb audio for compatability. It will have standart iem pins. And no, its not Bluetooth, its own wifi. I've calculated 7 hour of battery life solely on mcu draw, but i assume it will have probably 3-5 due to regulstors and dac etc. Based on 300mah rc helicopter battery. These are what I'm planning to implement

• An on board SD card for standalone play. Sd card will contain wav files in foldersz which act as playlists(i'll try flac, but not sure if mcu decode in real time).
• A male type c for phone/pc on top, and a 90 degree female on side, to be able to charge phone while listenin or powering transmitter for standalone mode
• Playback buttons both on earpiece and transmitter.
• A vu meter on transmitter. (maybe can try a small oled to make it more convinient to use on standalone mode as well)
• female 3.5mm and stereo mode switch on earpiece with no playback buttons. So it can be used for all kinds of speakers, headphones etc.

What do you think, and any suggestions as a possible future user? I'll make it open source, so you will make your own, or somebody in China will sell it.

I picked up a pair of speakers from marketplace and I was wanting to rebuild and update them a little since one of them doesn't seem to work properly and I've been learning and tinkering with electronics.

Currently, I'm only running my record player through them but I'm planning on running my Line 6 Helix through it too so I can play my guitars and basses through them as well. I know that may not be ideal but I'm limited on space so I'm trying to maximize utility lol.

TLDR; what driver recommendations do y'all have for 10" woofer, 6" mid, and 2" tweeter?

I really loved making these and they look & sound great